Gearshift Pedal Removal/Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
Apply locking agent to the set plate bolt threads (page
1-20).
Install the set plate [1] and bolt [2] and tighten the bolt to
Install the set plate
the specified torque.
with its punch mark
[3] facing out.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the wire clip [1].
Install the gearshift spindle cover [2] and bolts [3] and
tighten the bolts to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Route the wire harness properly (page 1-26).
Install the following:
– Clutch (page 12-12)
– Gearshift arm (page 12-21)
GEARSHIFT PEDAL
REMOVAL/INSTALLATION
Remove the pinch bolt [1] and gearshift arm [2] from the
gearshift spindle [3].
Remove the pivot bolt [4] and gearshift pedal [5].
Remove the dust seals [6].
Check the dust seals and tie-rod ball joint dust cover for
deterioration or damage, replace them if necessary.
Installation is in the reverse order of removal.
• Apply grease to the dust seal lips.
• Install the dust seals with the seal lip side facing out.
• Apply grease to the gearshift pedal pivot sliding area
(grease groove) of the pivot bolt.
• Align the slit of the gearshift arm with the punch
mark on the spindle
CLUTCH/GEARSHIFT LINKAGE (CRF1000/A)
[2]
[2]
[3]
[1]
[3]
[5]
[3]
[1]
[1]
[3]
Align
[2]
[4]
[6]
12-21