Honda CRF1000 Shop Manual page 509

dummyhead dummyhead
REAR WHEEL SPEED SENSOR INSTALLATION
• Route the hose, cable, and wire properly (page 1-
26).
Install rear wheel speed sensor [1] and a new bolt [2].
Tighten the bolt to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Install the rear brake bracket on the swingarm.
Install the clamps [3].
• Check the clearance gap between the sensor
bracket and pulser ring is 0.40 – 1.06 mm (0.016 –
0.042 in).
• The clearance gap cannot be adjusted.
If it is not within specification, check related part for
deformation, looseness, or damage.
Clamp the sensor wire [1] with the brake hose clamps.
Install brake hose clamp [2] and a new screw [3] with
the sensor wire and tighten the screw to the specified
torque.
TORQUE: 1.2 N·m (0.1 kgf·m, 0.9 lbf·ft)
Install brake hose guide [4] and new screws [5] and
tighten the screws to the specified torque.
TORQUE: 1.2 N·m (0.1 kgf·m, 0.9 lbf·ft)
Install the brake hose clamp [6] with the sensor wire
and bolt [7] and tighten the bolt to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Install the wire clips [8].
Install the wire clip [1].
Install the rear brake hose B [1] and rear wheel speed
sensor 2P (Black) connector [2] through the hole [3] of
rear fender B.
Connect the 2P (Black) connector.
Install new sealing washers [4], oil bolt [5], and rear
brake hose B and tighten the oil bolt to the specified
torque.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Install the rear wheel (page 18-4).
Fill brake fluid and bleed air from the brake hydraulic
system (page 19-7)
ANTI-LOCK BRAKE SYSTEM (ABS) (CRF1000A/D)
[4]
[2]
[1]
[3]
[3]
[1]
[2]
[7]
[5]
[3]
[8]
[1]
[1]
[2]
20-23
[6]
[4]/[5]