Honda CRF1000 Shop Manual page 404

dummyhead dummyhead
ENGINE REMOVAL/INSTALLATION
Disconnect the following:
CRF1000D:
– Clutch line EOP sensor 3P (Gray) connector [1]
– No.1 clutch EOP sensor 3P (Gray) connector [2]
– No.2 clutch EOP sensor 3P (Black) connector [3]
Remove the bolt [4] and stay [5].
CRF1000D: Disconnect the EOT sensor 2P (Black)
connector [1].
CRF1000D: Remove the EOT sensor [2].
Release the O
from the stay [4].
Remove the bolt [5] and stay.
Remove the drive sprocket bolt [1], washer [2], and
drive sprocket [3] from the countershaft and drive chain.
Remove the bolts [1] and left/right heel guards [2].
16-8
sensor 4P (Black) connector clip [3]
2
[4]
[5]
[5]
[1] [2]
[1]
Left side: Right side:
[2]
[1]
[2]
[3]
[1]
[4]
[3]
[2]
[3]
[2]