Alternator Cover Removal/Installation (Crf1000/A) - Honda CRF1000 Shop Manual

dummyhead dummyhead
ALTERNATOR/STARTER CLUTCH
ALTERNATOR COVER
REMOVAL/INSTALLATION
(CRF1000/A)
Drain the engine oil (page 3-12).
Remove the left rear cover (page 2-10).
Remove the gearshift spindle cover (page 12-17).
Disconnect the EOP switch terminal (page 22-19).
Disconnect the VS sensor 3P (Black) connector (page
4-42).
Remove the connector cover (page 5-8).
Disconnect
connector [1].
Disconnect the alternator 3P (Gray) connector [1].
Release the alternator assembly wire [2] from the wire
clamp [3].
Release the wire clip [4].
Release the alternator assembly wire from the frame.
Remove the following:
– Dipstick [1]
– Alternator cover bolts (6 x 28 mm) [2]
– Alternator cover bolt (6 x 30 mm) [3] and alternator
assembly wire cover stay A [4]
– Alternator cover bolt (6 x 30 mm) [5] and alternator
assembly wire cover stay B [6]
• Loosen the bolts in a crisscross pattern in 2 or 3
steps.
Remove the alternator cover [7].
• The
attracted to the flywheel, be careful during removal.
11-4
the alternator assembly
alternator cover (stator)
6P (Black)
[4]
[2]
[1]
[3]/[4]
is magnetically
[1]
[4]
[5]/[6] [7]
[3]
[2]
[1]
[2]
[2]