Honda CRF1000 Shop Manual page 409

dummyhead dummyhead
Install the stay [1] and bolt [2], and tighten the bolt
securely.
Install the O
stay.
CRF1000D: Install the EOT sensor [4] and a new
sealing washer [5], and tighten it to the specified torque.
TORQUE: 15 N·m (1.5 kgf·m, 11 lbf·ft)
CRF1000D: Connect the EOT sensor 2P (Black)
connector [6].
Connect the following:
CRF1000D:
– Clutch line EOP sensor 3P (Gray) connector [1]
– No.1 clutch EOP sensor 3P (Gray) connector [2]
– No.2 clutch EOP sensor 3P (Black) connector [3]
Install the stay [4] and bolt [5], and tighten the bolt to the
specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the clutch EOP sensor cover [1] and bolts [2],
CRF1000D:
and tighten the bolts to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Clamp the linear solenoid wire [3] and main wire
harness [4] with the wire clamp [5].
Connect linear solenoid 4P (Black) connector [1].
CRF1000D:
Install the wire band [2].
sensor 4P (Black) connector clip [3] to the
2
ENGINE REMOVAL/INSTALLATION
[2]
[6] [4]/[5]
[5]
[4]
[3]
[2]
[2]
[1]
[3]
[2]
[3]
[1]
[5]
[4]
[1]
[1]
16-13