Dtc 83 (Eop Sensor) (Crf1000D) - Honda CRF1000 Shop Manual

dummyhead dummyhead
PGM-FI SYSTEM
4. Front Wheel Speed Sensor Signal Output Line
Short Circuit Inspection
Check for continuity between the wire harness side
33P (Black) connector [1] and ground.
TOOL:
Test probe
Connection: B17 – Ground
Is there continuity?
YES
NO
5. ECM/PCM Inspection
Replace the ECM/PCM with a known good one
(page 4-39).
Connect the ABS modulator 18P (Black) connector.
Erase the DTC (page 4-6).
Test-ride the motorcycle above 20 km/h (12 mph)
for more than 20 seconds.
Stop the engine.
Check the DTC with the MCS.
Is DTC 67-1 indicated?
YES
NO

DTC 83 (EOP SENSOR) (CRF1000D)

Probable cause
• Open circuit in the Yellow/red or Gray/black wire
between the EOP sensor and PCM
• Open or short circuit in the White wire between the
EOP sensor and PCM
• Faulty EOP sensor
• Faulty PCM
DTC 83-1 (EOP SENSOR LOW VOLTAGE)
1. EOP Sensor System Inspection
Connect the MCS and start the engine.
Check the EOP sensor with the MCS.
Is about 0 V indicated?
YES
NO
4-36
07ZAJ-RDJA110
– Short circuit in the Blue/yellow wire
– GO TO STEP 5.
– Replace the ABS modulator with a known
good one (page 20-24) and recheck.
– Faulty original ECM/PCM
EOP SENSOR
Bl
– GO TO STEP 2.
– Intermittent failure
5 V
Y/R
W
Gr/Bl
[1]
B17
ECM/PCM
5 V