Oil Pressure Inspection; Oil Pump (Crf1000/A) Removal/Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead

OIL PRESSURE INSPECTION

Remove the engine oil filter cartridge (page 3-12).
Apply engine oil to the O-ring and install the oil pressure
attachment [1] onto the oil filter boss.
TOOL:
Oil pressure gauge attachment
Apply engine oil to the O-ring and install the engine oil
filter cartridge [2] onto the oil pressure attachment.
TOOL:
Oil filter wrench
TORQUE: 26 N·m (2.7 kgf·m, 19 lbf·ft)
Connect the oil pressure gauge [3] and attachment [4]
to the oil pressure gauge attachment.
TOOLS:
Oil pressure gauge set
Oil pressure gauge attachment
Fill the engine with the recommended engine oil
(page 3-12).
Warm the engine to normal operating temperature
(approximately 80°C/176°F) and increase the engine
speed to 5,000 min
STANDARD:
499 – 637 kPa (5.1 – 6.5 kgf/cm
at 5,000 min
Stop the engine and remove the tools.
Install the engine oil filter cartridge (page 3-12).
OIL PUMP (CRF1000/A)
REMOVAL/INSTALLATION
Remove the oil strainer (page 9-8).
Remove the bolts [1] and oil pump [2].
Installation is in the reverse order of removal.
• Align the oil pump driven shaft end with the oil pump
drive shaft groove.
070MJ-0010101
07HAA-PJ70101
07506-3000001 or
equivalent
commercially
available
07406-0030000 or
equivalent
commercially
available
-1
(rpm) and read the oil pressure.
2 , 72 – 92 psi)
-1 (rpm)/(80°C/176°F)
LUBRICATION SYSTEM
[2]
[3]
[4]
[1]
Align [2]
[1]
9-5