Headlight Aim; Clutch System (Crf1000/A) Maintenance - Honda CRF1000 Shop Manual

dummyhead dummyhead
MAINTENANCE

HEADLIGHT AIM

Place the motorcycle on a level surface.
Adjust the headlight beams vertically by turning the
Adjust the headlight
vertical beam adjuster [1].
beam as specified
by local laws and
regulations.
CLUTCH SYSTEM (CRF1000/A)
Measure the clutch lever freeplay at the end of the
clutch lever.
FREEPLAY:10 – 20 mm (0.4 – 0.8 in)
Minor adjustment is made with the upper adjuster at the
The adjuster may
clutch lever.
be damaged if it is
positioned too far
Loosen the lock nut [1] and turn the adjuster [2].
out, leaving minimal
If the adjuster is threaded out near its limit and the
thread
correct freeplay cannot be obtained, turn the adjuster all
engagement.
the way in and back out one turn.
Tighten the lock nut while holding the adjuster.
Recheck the clutch lever freeplay.
Major adjustment is made with the lower adjusting nut
[1] at the clutch lifter arm.
Loosen the lock nut [2] and turn the adjusting nut to
adjust the freeplay.
Tighten the lock nut while holding the adjusting nut.
If proper freeplay cannot be obtained, or the clutch slips
during test ride, inspect the clutch (page 12-8).
3-22
[1]
10 – 20 mm
(0.4 – 0.8 in)
[1]
[2]
[2]
[1]