Shift Control Motor/Reduction Gears Removal - Honda CRF1000 Shop Manual

dummyhead dummyhead
Apply engine oil to the primary drive gear nut threads
and seating surface.
Install the washer [1] and primary drive gear nut [2].
Install the special tool between the primary drive and
driven gears, and tighten the nut (left-hand thread) to
the specified torque.
TOOL:
Gear holder, 2.5 [3]
TORQUE: 118 N·m (12.0 kgf·m, 87 lbf·ft)
Remove the 6 mm bolt [4] to free the primary drive gear
and sub-gear.
Install the right crankcase cover (page 13-55).
SHIFT CONTROL MOTOR/REDUCTION
GEARS
REMOVAL
Remove the bolts [1] and shift control motor cover [2].
Disconnect the shift control motor 2P (Black) connector
[1].
Remove the torx bolts [2], shift control motor [3], and O-
ring [4].
Remove the torx bolts [1] and reduction gear cover [2].
DUAL CLUTCH TRANSMISSION (DCT) (CRF1000D)
[4]
07724-0010100
[3]
[3]
[1]
[2] [4]
[2]
[1]/[2]
[2]
[1]
[1]
13-71