Turn Signal Relay - Honda CB HORNET 160R 2015 Shop Manual

INSPECTION
Connect the ohmmeter to the passing relay connector
terminals.
CONNECTION:
Connect the battery to the passing relay connector
terminals.
CONNECTION:
Refer to the chart, and check for continuity between the
terminals when 12V battery is connected.
12V battery is
connected
12V battery is
not connected

TURN SIGNAL RELAY

INSPECTION
1. Recommended Inspection
Check the following:
– Battery condition
– Burned out bulb or non - specified wattage
– Burned fuse
– Combination and turn signal switches function
– Loose connector
Are the above items in good condition?
NO – Replace or repair the malfunction part(s)
YES – GO TO STEP 2.
2. Turn Signal Circuit Inspection
Remove the front cowl (page 2-5).
Disconnect the turn signal relay 2P White connector from
the turn signal relay.
Short the Black and Gray terminals of the turn signal relay
connector with a jumper wire.
Start the engine and check the turn signal light by turning
the switch "ON".
Is the light come on?
YES – • Faulty turn signal relay
• Poor connection of the connector
NO – Open circuit in Black or Gray wires
REMOVAL/INSTALLATION
Remove the front cowl (page 2-5).
Disconnect the turn signal relay 2P White connector from
the relay.
Remove the turn signal relay from the bracket.
Installation is in the reverse order of removal.
A – D
A – E
B – C
A – D A – E
Continuity No Continuity
No Continuity Continuity
LIGHTS/METERS/SWITCHES
L
G
L/B
B
L/R
TURN SIGNAL RELAY
2P CONNECTOR
JUMPER WIRE
TURN SIGNAL RELAY
2P CONNECTOR
TURN SIGNAL RELAY
TURN SIGNAL RELAY
2P CONNECTOR
A
D
C
E
B
17-17