Starter Relay Removal/Installation; Starter Relay Operation Inspection - Honda CRF110F Service Manual

ELECTRIC STARTER
Install and tighten the motor case screws [lJ .
Install the ground cable terminal [1] and tighten the
~=====;;:;;;::;====.:::::==;_=~
screw [2J.
Install the starter motor cable terminal (3] and tighten
the screw [4] to the specified torque.
TORQUE : 2 N'm (0.2 kgf'm, 1.5IbHt)
Put back the dust cover [5] in the appropriate position.
STARTER RELAY
REMOVAL/INSTALLATION
Remove the left side cover (page 2-4).
Release the starer relay [lJ from the battery case and
Disconnect the starter relay 5P connector [2].
OPERATION INSPECTION
Remove the left side cover (page 2-4).
Shift the transmission into neutra!.
Turn the ignition switch to ON and engine stop switch to
.0" , push the starter switch .
The coil is normal if the starter relay [1] clicks.
If you don't hear the click, inspect the starter relay
circuits (page 5-10).
5-9