Turn Signal Relay - Honda C8R600F4 Service Manual

LIGHTS/METERS/SWITCHES
TURN SIGNAL RELAY
1Q-1R
Turn signal light does not blink
Remove the seat cowl (page 2-2).
Disconnect the turn signal relay connector.
Connect the Black/brown and Gray wire terminals
of the wire harness side connector with o jumper
wire.
Turn the ignition switch ON and check the turn sig-
nal light by operating the turn signal switch.
•If the light does not come on, check for open cir-
cuit in Black/brown and Gray wires.
•If the light comes on, check for continuity be-
tween the Green wire terminal and body ground.
- If there is no continuity, check for open circuit in
green wire.
- If there is continuity, check the connector termi-
nals for loose or poor contact.
If the connector terminals are OK, replace the
turn signal relay.
49 state/California type shown:
TURN SIGNAL RELAY
I