Docsis 2.0 Logical Channel Configuration Task Summary; Configuring The Channel Type - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide
Note: Only the Primary (and Standby) 2:8 DOCSIS 2.0 CMTS Module
supports the configuration of logical channels.

DOCSIS 2.0 Logical Channel Configuration Task Summary

A summary of tasks for configuring DOCSIS 2.0 is listed in below:
Task
1. Confirm that your BSR2000 hardware
configuration supports DOCSIS 2.0
2. Enable Spectrum Power Density
Maintenance
3. Assign a channel type to a logical channel
4. For logical channels assigned an
S-CDMA channel type, configure
additional S-CDMA related parameters
5. Review the configuration

Configuring the Channel Type

The cable upstream channel-type command allows you to specify the channel type
for the default upstream channel (0) or specify the channel type for up to four logical
channels (0-3).
Follow this procedure to configure the channel type for an upstream channel:
1. Navigate to Cable Interface Configuration mode, as follows:
6-24
The Motorola implementation of DOCSIS 2.0 offers 128QAM and 256QAM in
addition to those specified in the CableLabs DOCSIS 1.0, 1.1, and 2.0
specifications.
Table 6-5 DOCSIS 2.0 Configuration Task Summary
MOT(config)#interface cable <X/Y>
where:
Refer to...
Configuring the Channel Type
Configuring Spectrum Power
Density Maintenance for a Logical
Channel
Configuring the Channel Type
Additional S-CDMA Logical
Channel Configurations
Displaying the Upstream Logical
Channel Configuration
MGBI
Release 1.0
526360-001-00 Rev. B