Motorola BSR 2000 Configuration And Management Manual page 426

BSR 2000 Configuration and Management Guide
3. Issue the interface cable command to enter a cable interface:
4. Issue the cable dynamic-service authorization-mode command in Interface
5. Issue the end command to exit the cable interface and return to Global
6. Repeat
7. Issue the show cable dynamic-service command to verify the dynamic service
Figure 7-11 Output for the show cable dynamic-service Command.
8. Issue the show packet-cable configuration dqos command to verify the DQoS
7-30
MOT(config)# interface cable <X/Y>
where:
X is 0.
Y is the port number.
Configuration mode to allow each PacketCable cable interface to accept dynamic
service:
MOT(config-if)# cable dynamic-service authorization-mode
{auth_no_ecn02064 | authorize | unauthorize}
where:
auth_no_ecn02064 authorizes Dynamic Service based on DQoS gates
without PacketCable ECN 2064 support.
authorize authorizes CM initiated Dynamic Service based on DQoS gates.
This argument is required when DQoS is enabled.
unauthorize accepts all Dynamic Service.
Configuration mode.
Step 3 through
service.
configuration status for the configured cable interfaces.
Figure 7-11 displays typical show cable dynamic-service command output:
MOT(config-if)#show cable dynamic-service
Cable dynamic-service auth-mode: authorize
Cable dynamic-service active-timeout: 0
Cable dynamic-service loadbalance: disable
configuration.
Step 5 if more cable interfaces need to accept dynamic
MGBI
Release 1.0
526360-001-00 Rev. B