Displaying Service Flow Statistics - Motorola BSR 2000 Configuration And Management Manual

Release 1.0
Use the show interfaces cable service-class command, in all modes except User
EXEC, to display interface level service class information for all downstream and
upstream service classes, downstream service classes, or upstream service classes that
are active on the BSR:
MOT# show interfaces cable <X/Y> service-class [all | downstream | upstream]
where:

Displaying Service Flow Statistics

Follow these steps to find an SFID and display service flow statistics for the desired
SFID:
1. Use the show cable modem svc-flow-id command in Privileged EXEC mode to
Note: "no restriction" indicates that there is no traffic rate limit for this service.
MOT# show cable modem {<mac> | <prefix>} svc-flow-id
where:
526360-001-00 Rev. B
X is 0.
Y is the port number.
all displays both upstream and downstream service class information
downstream displays downstream service class information only
upstream display upstream service class information only
display the Service Flow ID (SFID) of all the service flows used by a specific
CM, which includes the upstream or downstream channel direction and the
maximum sustained flow rate for the SFID in bits-per second:
mac is the CM MAC address.
prefix is the CM IP address.
MGBI
Configuring the CMTS
6-115