Motorola BSR 2000 Configuration And Management Manual page 296

BSR 2000 Configuration and Management Guide
6-110
where:
WORD is the service class name.
0-65535 is the maximum upstream burst size.
Use the activity-timeout command in Cable Service Class mode to specify the
amount of time that an active service flow can be unused if there is no activity on
the service flow within the time-out interval:
MOT(config-srvclass)# activity-timeout <WORD> <0-65535>
where:
WORD is the service class name.
0-65535 is the timeout in seconds.
Use the admission-timeout command in Cable Service Class mode to specify the
amount of time that reserved resources are allowed to exceed the active time-out
of the service flow. Reserved service flow resources are released when a Dynamic
Service Change (DSC) message is received by the CMTS from a CM after the
admission time-out interval expires.
MOT(config-srvclass)# admission-timeout <WORD> <0-65535>
where:
WORD is the service class name.
0-65535 is the time-out in seconds.
Use the req-trans-policy command in Cable Service Class mode to specify
which Interval Usage Code (IUC) opportunities a CM may use for upstream
requests and packet transmissions, whether requests for bandwidth can be
piggy-backed with packet transmissions, and if data transmissions are
concatenated, fragmented or payload header suppression (PHS) is allowed:
MOT(config-srvclass)# req-trans-policy <WORD> <0x0-0x7fff>
where:
WORD is the service class name.
0x0-0x7fff is the policy bit mask.
MGBI
Release 1.0
526360-001-00 Rev. B