Displaying The Packet Classifier; Displaying Sfid And Qos Information - Motorola BSR 2000 Configuration And Management Manual

Release 1.0

Displaying the Packet Classifier

A service flow classifier matches a packet to a service flow using a service flow
reference. The service flow reference associates a packet classifier encoding with a
service flow encoding to establish a SFID. Classifiers have the following features:
Use the show cable qos svc-flow classifier command in Privileged EXEC mode to
display the packet classifiers of a service flow configured on the cable interface:
MOT# show cable qos svc-flow classifier [<X/Y> [<1-4292967295>] [<1-65535>]]]
where:
Note: If the Classifier ID is not given, all the classifiers with the given SFID
are listed.

Displaying SFID and QoS Information

Use the show cable qos svc-flow summary command in Privileged EXEC mode to
display service flow identifier (SFID) and QoS parameter information:
MOT# show cable qos svc-flow summary [<X/Y> [<1-4292967295>]]
where:
526360-001-00 Rev. B
Displaying Upstream Service Flow Statistics
Displaying Payload Header Suppression Entries
Displaying Class of Service (Qos) Profiles
Classifiers are loosely ordered by priority.
Several classifiers can refer to the same service flow.
More than one classifier may have the same priority.
The cable interface uses a downstream classifier to assign packets to downstream
service flows.
The CM uses an upstream classifier to assign packets to upstream service flows.
X is 0.
Y is the port number.
1-4292967295 is the Service Flow Identifier (SFID).
1-65535 is the classifier identifier..
MGBI
Configuring the CMTS
6-127