Motorola BSR 2000 Configuration And Management Manual page 318

BSR 2000 Configuration and Management Guide
4. Use the show running configuration command with the following parameters to
interface cable 0/0
cable bundle 1
no ip address
no shutdown
cable bind downstream 0
cable downstream 0 modulation 64
cable downstream 0 power-level 630
no cable downstream 0 shutdown
cable bind upstream 0,1,2,3
cable upstream 0 modulation-profile 2
cable upstream 0 shutdown
cable upstream 1 frequency 10000000
cable upstream 1 channel-width 1600000
cable upstream 1 modulation-profile 2
cable upstream 1 spectrum-group srv-grp1
no cable upstream 1 shutdown
cable upstream 2 frequency 30000000
cable upstream 2 spectrum-group srv-grp1
cable upstream 2 shutdown
cable upstream 3 shutdown
cable dynamic-service authorization-mode unauthorize
ip dchp relay information option
cable downstream schedule priority-wfq
!
5. Define the following five QoS Profiles in the BSR 2000 running configuration
6-132
MOT(config-if)#[05/14-15:22:31.31- 07:console]-N-configuration
change by [console]: cable dynamic-service authorization-mode
unauthorize
verify that the cable dynamic-service authorization-mode unauthorize
command was accepted by the BSR.
MOT# show run | begin interface cable <X/Y>
where:
X is 0.
Y is the port number.
The command will display output similar to the following. Find the line "cable
dynamic-service authorization-mode unauthorize" to confirm that the command
issued in Step 3 was accepted by the BSR.
file. Refer to the section,
procedure.
Creating or Modifying a QoS
MGBI
Release 1.0
Profile, that precedes this
526360-001-00 Rev. B