Displaying Electronic Surveillance Information - Motorola BSR 2000 Configuration And Management Manual

Release 1.0
Note: Electronic surveillance conforms to Communications Assistance for
Law Enforcement Act (CALEA) requirements.
Issue the following commands to clear electronic surveillance information:

Displaying Electronic Surveillance Information

Use the following commands in all modes except User EXEC mode to display
electronic surveillance information. Refer to the BSR 2000 Command Reference
Guide for detailed command output information.
526360-001-00 Rev. B
Issue the es trap-enable command to enable or disable the electronic
surveillance SNMP trap:
MOT (config-pktcable) # es trap-enable {disable | enable}
where:
disable disables the electronic surveillance SNMP trap.
enable enables the electronic surveillance SNMP trap. The default is
disabled.
Issue the clear packet-cable statistics es identifier command in Privileged
EXEC mode to clear
MOT# clear packet-cable statistics es identifier {<0x00000000-0xffffffff>}
where:
0x00000000-0xffffffff optionally clears a specific ES identifier.
Issue the clear configuration es command in PacketCable Configuration mode
to clear electronic surveillance SNMP traps and reset es trap-enable to
"disabled".
show packet-cable configuration es command
Issue the
configuration information.
surveillance
duplicated packet and byte counts
MGBI
Configuring PacketCable
:
display
to electronic
7-27