BSR 2000 Configuration and Management Guide
You initially begin a CLI session in User EXEC mode, which has a limited set of
commands. To have access to all EXEC commands, you must enter Privileged EXEC
mode which is usually password protected. From Privileged EXEC mode, you can
access Global Configuration mode which is the gateway to all other configuration
modes.
Note: Any changes made in any command line interface mode only remain in
effect until you reboot the system. To make a change permanent, you must
save your running configuration file to the startup configuration file.
User EXEC Mode
When you first access the CLI, you are initially in the User EXEC mode indicated by
the MOT > prompt. User EXEC commands are a limited subset of commands
available in the next CLI level (Privileged EXEC mode). User EXEC commands
allow you to perform basic tests and list system information.
2-4
•
User EXEC Mode
•
Privileged EXEC Mode
Configuration command line interface modes allow you to make changes to the
BSR's running configuration. The configuration modes are as follows:
•
Global Configuration Mode
•
Interface Configuration Mode
•
Service Class Configuration Mode
•
PacketCable Configuration Mode
•
PacketCable Configuration Mode
•
IPSec Configuration Mode
•
Router Configuration Mode
•
Route Map Configuration Mode
•
Cable Spectrum Group Mode
MGBI
Release 1.0
526360-001-00 Rev. B