BSR 2000 Configuration and Management Guide
Figure 6-4
specific CM:
Service flow id
Figure 6-4 show cable modem svc-flow-id Command Output
2. Use the show cable qos svc-flow statistics command to display the service flow
Displaying Service Class Statistics
If you want to view statistics for a service class on the BSR, issue the show cable
srvclass-stats command in Service Class Configuration mode:
MOT(config-srvclass)# show cable srvclass-stats [<X/Y> <WORD>]
where:
Setting QoS Parameters
This section describes how to configure Quality of Service (QoS) using service flows.
Use the commands in this section to create, change, or delete service flows with
Dynamic Service Addition (DSA), Dynamic Service Change (DSC), and Dynamic
Service Deletion (DSD) MAC management messages. Configuring QoS involves the
following tasks:
6-116
displays typical show cable modem svc-flow-id command output for a
Interface
51
cable
52
cable
statistics for all service flows, a specific cable interface, or a specific service
flow:
MOT# show cable qos svc-flow statistics [<X/Y>] [<1-4292967295>]
where:
X is 0.
Y is the port number.
1-4292967295 is the SFID number.
X is 0.
Y is the port number.
WORD is the service class name.
Creating or Modifying a QoS Profile
Flow Direction
5/0
Upstream
5/0
Downstream
MGBI
Release 1.0
Flow Max Rate
no restriction
no restriction
526360-001-00 Rev. B