Motorola BSR 2000 Configuration And Management Manual page 407

Release 1.0
Configuring the Priority for Event Messages
Based on the overall PacketCable network, the Record Keeping Server can prioritize
event messages from the BSR. The higher the number, the lower the priority.
Issue the em event-priority command in PacketCable Configuration mode to
configure the priority value of event messages generated from the BSR relative to
other events:
MOT(config-pktcable)# em event-priority <0-255>
where:
Configuring the UDP Port for Event Messages
If the default UDP port is already in use, another UDP port can be configured for
PacketCable event messages. A different UDP port can also be configured for event
messages to enhance security.
Issue the em udp-port command in PacketCable Configuration mode to configure a
UDP port number for event messages:
MOT(config-pktcable)# em udp-port <1-65535>
where:
Configuring the Retry Interval
When a Record Keeping Server receives and records an Accounting-Request event
message from the BSR, it sends an Accounting-Response message to the BSR. If the
BSR does not receive an Accounting-Response message within the configured retry
interval, it sends another Accounting-Request message to the Record Keeping Server.
The event message retry interval can be configured depending on the amount of
network congestion and the distance between the BSR and the Record Keeping
Server. For example, if the distance caused a time delay, the event message retry
interval can be extended from the default value to allow more time for the BSR to
receive an Accounting-Response message. The network and the Record Keeping
Server should be examined to determine the reason for these timeouts. In most cases
the em retry-count command parameter should be increased before the em
retry-interval command parameter is modified.
Issue the em retry-interval command in PacketCable Configuration mode to
configure the event message retry interval for receiving an Accounting Response.
526360-001-00 Rev. B
0-255 is the event priority ranking. The default is 128.
1-65535 is the UDP port number. The default is 1813.
MGBI
Configuring PacketCable
7-11