Table of Contents
Advertisement
Chapter 2: MWR Device Installation
MWR Device Deployment and Installation
The MWR device requires professional installation to ensure that the installation is performed in
accordance with FCC licensing regulations. All common precautions for grounding and electrostatic
discharge protection should be observed during deployment and installation.
Observe the following additional guidelines when deploying fixed Infrastructure devices (MWR and
IAP):
•
•
•
•
•
•
Assembling the MWR Device
Use the following procedure to assemble a MWR Device.
Procedure 2-1 Assembling the MWR Device
1
Place the brackets at the desired position on the pole.
2
Adjust the position of the box so that the antenna connecters are positioned vertically. Align the antennas
with the N-type connectors on the box and rotate to close.
Insert the cable into the external Ethernet port and tighten the connector to ensure a weatherproof seal.
3
Insert the Power Plug into the 4-pin connector.
4
Initial MWR Device Configuration Information
Prior to attempting configuration of a MWR device, the device must be powered up and have
connectivity to the MiSC.
The Geo-location coordinates are entered into an infrastructure device via the Device Manager
Network management tool installed on the MeshManager server (refer to the MeshManager Users
Guide). Motorola recommends that a DGPS receiver be used to obtain accurate GPS coordinates.
6881011Y53-O September 2005
The MWR may be mounted on a pole having a diameter of 1-3.5 inches, utilizing the
provided bracket.
The antenna must have a separation distance of at least 2 meters from the body of all
persons and must not be co-located or operating in conjunction with any other antenna
or transmitter.
Users and installers must be provided with antenna installation and transmitter operating
conditions to satisfy RF exposure compliance.
When deploying the MWR, the antenna should be a minimum of 30 inches from any
nearby metal poles to avoid distortion of the RF pattern.
The installation location must provide power to the MWR.
It is the responsibility of the Network Operator to ensure that the installation complies
with any local building codes and permits.
2-6
Advertisement
Table of Contents
