Configuring Ipsec And Ike Parameters - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide

Configuring IPSec and IKE Parameters

Follow the procedures in these sections to configure IPSec and IKE network
parameters:
Configuring IKE Retransmissions
Follow these steps to configure the number of IKE retries for network problems:
1. Issue the ipsec command in Global Configuration mode to enter IPSec
2. Issue the show ipsec ike command in IPSec Configuration mode.
3. Observe the number of IKE retries in the show ipsec ike command output. If the
4. Issue the ike retries command to configure the number of IKE retries:
Configuring the IKE Retransmission Timeout Interval
Follow these steps to configure the IKE retransmission timeout interval for network
problems.
1. Issue the ipsec command in Global Configuration mode to enter IPSec
2. Issue the show ipsec ike command in IPSec Configuration mode.
3. Observe the number of IKE timeouts in the show ipsec ike command output. If
7-22
Configuring IKE Retransmissions
Configuring the IKE Retransmission Timeout Interval
Configuring the IKE Phase 1 Lifetime Interval and Lifesize Value
Configuring the IKE Phase 2 Lifetime Interval and Lifesize Value
Configuration mode.
number of IKE retries is increasing, then the network and server should be
examined to determine the reason for the excessive number of IKE retries.
MOT(config-ipsec)# ike retries <1-10>
where:
1-10 is the retries permitted. The default is 3.
Configuration mode.
the number of IKE timeouts is increasing, then the network and server should be
examined to determine the reason for the excessive number of IKE timeouts.
MGBI
Release 1.0
526360-001-00 Rev. B