Configuring A Trap Destination; Specifying The Destination Ip Address - Motorola BSR 2000 Configuration And Management Manual

Broadband services router
Hide thumbs Also See for BSR 2000:
Table of Contents

Advertisement

Release 1.0
In DOCSIS logging control mode, the logging rate-limit command controls both the
trap and SYSLOG throttling limits. The snmp-server trap rate-limit command is
disabled in this mode.

Configuring a Trap Destination

The SNMP Agent maintains a configuration of IP hosts to which traps are sent. Each
entry in the table contains:
Trap destinations are specified with the snmp-server host command. This command
is intended to simplify trap configuration by automatically generating entries in
multiple standard tables from rfc2573 such as the snmpNotifyTable,
snmpTargetAddrTable, and snmpTargetParamsTable. These tables can also be
manipulated directly through the CLI. Refer to the BSR 2000 Command Reference
Guide for detailed descriptions of the associated CLI commands.
Note: Before to using the
configure a community string for
Defining a Community Name
Security
A maximum of 40 remote hosts can be specified with the snmp-server host
command.

Specifying the Destination IP Address

1. Use the snmp-server host command in Global Configuration mode to specify a
526360-001-00 Rev. B
The IP address of the trap destination
The community or user name to send in the trap message
The host destination configured to receive specific trap types
The SNMP format (v1, v2c, or v3) of the trap PDU to use for that destination
on page 4-28 respectively.
destination machine to receive SNMP trap information. This command is
disabled by default, specifying that no trap notifications are sent. If you enter the
snmp-server host command with no keywords, all trap types are sent to the host.
MOT (config)#snmp-server host <A.B.C.D> {<WORD>}{[traps | informs]
[version {1 | 2c | 3 [auth | noauth | priv]}{<WORD>}}
where:
host-address is the destination machine to receive SNMP trap information.
snmp-server host
SNMPv1/v2c
on page 4-26 and
MGBI
Configuring SNMP
command, the user should
SNMPv3 user
name. See
or an
Configuring USM and VACM
4-9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bsr 64000

Table of Contents