Using A Telnet Session To Access The Cli; Cli Command Modes - Motorola BSR 2000 Configuration And Management Manual

Release 1.0

Using a Telnet Session to Access the CLI

This section describes accessing the CLI by establishing a telnet session to the BSR.
Note: If an IP address has not been configured for the Ethernet interface and
a password has not been configured for the BSR, you can not access the
BSR through telnet. Refer to
passwords and telnet parameters, and
configuring an Ethernet interface.
To establish a Telnet session with the BSR, do the following:
1. Start the telnet application. Enter the host name or the IP address of the BSR in
2. Press Enter. The following prompt displays:
3. Enter the following command:
4. Enter the password and press the Enter key to access Privileged EXEC mode.
5. To terminate the Telnet connection and exit the Telnet application, enter exit at
For a detailed discussion of the different command line modes, refer to the
Command Modes

CLI Command Modes

The command line interface is organized into different command modes. Each
command mode has its own set of commands available for configuring and
monitoring the BSR and network operations.
each command mode, the prompt display, navigating through the command mode
hierarchy, and exiting each command mode.
526360-001-00 Rev. B
the appropriate field or system prompt.
MOT >
MOT > enable
This brings you to Privileged EXEC mode. A Password: prompt displays.
The MOT # prompt displays.
the prompt in Privileged EXEC mode.
section.
EXEC command line interface modes are used to navigate the CLI and perform
basic BSR startup, configuration, and monitoring tasks. The EXEC modes are as
follows:
Using the Command Line Interface
Chapter 3 for information on setting system
Chapter 5
Table 2-2
MGBI
for information on
CLI
provides details on entering
2-3