Release 1.0
Deleting Security Policy Database Policy Entries
Follow these steps to delete Security Policy Database (SPD) policy entries:
1. Issue the no spd policy command in IPSec Configuration mode to delete SPD
Note: Use caution when deleting more than one SPD entry, because the
SPD index numbers change whenever an index is deleted.
2. Issue the show ipsec spd policy command to verify if the appropriate SPD policy
Displaying the IPSec Configuration
Use the following commands in all modes except User EXEC mode to display the
IPSec configuration.
526360-001-00 Rev. B
entries when they are no longer needed. A single rule or all the rules in the table
can be deleted at once:
MOT(config-ipsec)# no spd policy {all | <num>}
where:
all deletes all entries in the SPD.
num deletes a specific rule from the SPD specified by the index number.
was deleted.
Issue the show ipsec ike command to display the IKE configuration.
MGBI
Configuring PacketCable
7-25