Clearing Ucc Or Dcc Statistics; Configuring Cable Intercepts; Enabling A Cable Intercept - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide

Clearing UCC or DCC Statistics

Use the following commands to clear statistics displayed with show cable ucc-stats
and show cable dcc-stats commands:
MOT#clear cable ucc-stats [X/Y]
MOT#clear cable dcc-stats [X/Y]
where:

Configuring Cable Intercepts

The Cable Intercept feature provides a way to monitor and intercept data originating
from a DOCSIS network. The Cable Intercept feature provides Multiple System
Operators (MSOs) with Lawful Intercept capabilities required by the
Communications Assistance for Law Enforcement Act (CALEA) for electronic
surveillance. Lawful Intercept capabilities are used by law enforcement agencies to
conduct electronic surveillance of circuit and data communications.
Warning: Lawful Intercept capabilities to intercept customer traffic are
authorized by either a judicial means to support local laws or through an
administrative order governed by service level agreements (SLAs). The
proper legal or administrative persons must be contacted first before
customer traffic is intercepted and examined.
When the Cable Intercept feature is initiated, copies of the data transmissions from
and to a specified Customer Premises Equipment (CPE) MAC address (such as a PC)
are sent to an intercept collector, which is a server at a specified IP address and UDP
port number.
Each CMTS module supports a maximum of 16 cable intercept entries in the startup
configuration and running configuration files. Only one MAC address per CPE
device, such as a PC can be intercepted and only packets from these CPEs are
intercepted.

Enabling a Cable Intercept

Follow these steps to intercept data for a particular CPE on a DOCSIS network:
6-184
X is 0.
Y is the MAC Domain.
MGBI
Release 1.0
526360-001-00 Rev. B