Specifications; Enabling Ospf - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide
The following optional tasks are used to manage OSPF on the BSR 2000™:

Specifications

The BSR supports the following Request for Comment (RFC) specifications:
RFC 2328 — OSPF Version 2
RFC 1587 — The OSPF NSSA Option

Enabling OSPF

Follow these steps to enable OSPF, create the OSPF routing process, specify the range
of IP addresses associated with the routing process, and assign the area IDs associated
with that range of IP addresses:
1. Use the router ospf command in Global Configuration mode to enable OSPF
2. Use the network area command in Router Configuration mode to specify the
11-2
Redistributing Routes into OSPF
Configuring OSPF Area Parameters
Managing OSPF on the BSR
Configuring OSPF on an Interface
Gathering OSPF Information
routing and enter Router Configuration mode:
MOT (config)#router ospf
OSPF network, wildcard mask and Area ID:
MOT (config-ospf)#network <A.B.C.D> <A.B.C.D> area
[<0-4294967295> | <A.B.C.D>]
where:
A.B.C.D is the IP address of the OSPF network.
A.B.C.D is the IP address type mask with don't care bits (wildcard bit mask).
0-4294967295 is the area number.
A.B.C.D is the network area IP address. If areas are associated with IP
subnets, subnet area may be specified.
MGBI
Release 1.0
526360-001-00 Rev. B