Displaying Gates - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide

Displaying Gates

Issue the following show commands in all modes except User EXEC mode to display
gate information. Refer to the BSR 2000 Command Reference Guide for detailed
command output information.
7-32
The BSR clears all resources reserved for a gate (depending on the state of the
gate) when the DQoS gate Timer T1 expires, which causes the MTA or Client to
delete the gate.
Issue the dqos t1-timer command in PacketCable Configuration mode to
configure the T1 timer:
MOT(config-pktcable)# dqos t1-timer <1-3600>
where:
1-3600 is the timer value in seconds. The default is 250.
Issue the show packet-cable gate command to display the gate ID in
hexidecimal notation, CM MAC address, CPE (subscriber) IP address, cable
interface slot number (always 0 for the BSR 2000), upstream and downstream
Service Flow Identifier (SFID) number, status and committed time gate summary
information.
MGBI
Release 1.0
526360-001-00 Rev. B