Entering A Description Of The Downstream Port; Managing The Downstream Channel - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide
2. Use the show interfaces cable command in Interface Configuration mode to

Entering a Description of the Downstream Port

Optionally issue the cable downstream description command in Interface
Configuration mode to specify descriptive information for the downstream port that
you are configuring. This information is limited to 80 characters and spaces cannot be
used.
Note: The entered description can be seen in the running configuration, and
in the command output of
command.
MOT (config-if)# cable downstream <0-1> description <LINE>
where:
For example:

Managing the Downstream Channel

The tasks in this section involve some parameters that you may choose to change. If a
parameter default is satisfactory, you can ignore its associated task.
The tasks in this section are used to manage the operation of the downstream channel:
6-48
MOT (config-if)# no cable downstream shutdown
verify that the downstream port is enabled:
MOT (config-if)# show interfaces cable <X/Y>
where:
X is 0.
Y is the port number.
0-1 is the downstream port number.
LINE is the text that describes the downstream port.
MOT (config-if)# cable downstream 0 description charlestown_1D
Configuring the Downstream Interleave Depth
Setting the Downstream Power Level
Resetting a Downstream Port
show commands such as the
MGBI
Release 1.0
show ip interface
526360-001-00 Rev. B