Enabling Vlan Stacking Through The Cli - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide
Motorola vendor-specific TLV
–Type = 43
–Length = 26
–Subtype=8
–Length=3
–Value=0x08003E
–Subtype = 3
–Length = 19
–Value = "vlan:<VLAN identifying number> stackable"

Enabling VLAN Stacking through the CLI

The Command Line Interface (CLI) can be used to enable or disable VLAN stacking.
1. Use the bridge cable modem command to enable VLAN stacking for a particular
2. Use the no bridge cable modem command to disable VLAN stacking for a
13-10
cable modem, as follows:
bridge cable modem <mac> <2-4094> stackable
MOT(config)#
where:
mac is the cable modem's MAC Address in the form xxxx.xxxx.xxxx.
2-4094 is the VLAN ID number.
stackable enables VLAN stacking.
particular cable modem, as follows:
no bridge cable modem <mac> <2-4094> stackable
MOT(config)#
Indicates that
VLAN stacking is enabled.
MGBI
Release 1.0
526360-001-00 Rev. B