Enabling Ebgp Multihop For Neighbor And Peer Groups - Motorola BSR 2000 Configuration And Management Manual

Release 1.0
Example
The commands in the following example set the minimum time between sending BGP
routing updates to 4 seconds:

Enabling EBGP Multihop for Neighbor and Peer Groups

Normally, EBGP neighbors are directly connected. When EBGP neighbors do not
connect directly, use the neighbor ebgp-multihop command to specify that the
neighbor is more than one hop away.
MOT(config-bgp)#neighbor {<A.B.C.D> | <WORD>} ebgp-multihop
[<1-255>]
where:
Example
The commands in this example configure Router Miami, as shown in
Figure 12-6
external peer. Because Router Miami and Router Washington are connected together
via Router Boston, rather than by a direct link, the neighbor ebgp-multihop
command is used.
526360-001-00 Rev. B
WORD is the name of the BGP peer group.
0-600 is the advertisement interval time in seconds.
MOT(config)#router bgp 100
MOT(config-bgp)#neighbor 3.3.3.3 advertisement-interval 4
A.B.C.D is the IP address of the BGP neighbor.
WORD is the name of the BGP peer group.
1-255 is the time-to-live in the range which is a value from 1 to 255 hops.
MOT(config)#router bgp 100
MOT(config-bgp)#neighbor 1.1.1.1 remote-as 200
MOT(config-bgp)#neighbor 1.1.1.1 ebgp-multihop
shows Router Miami is configured with Router Washington as an
MGBI
Configuring BGP
Figure 12-6:
12-19