Enabling Informs; Enabling Traps - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide

Enabling Informs

Use the snmp-server enable informs command in Global configuration mode to
enable SNMP Informs:
MOT (config)#snmp-server enable informs
To disable informs, use the no snmp-server enable informs command.
Note: For SNMP informs to be sent, you must also SNMP enable traps with
the snmp-server enable traps command even if there are no hosts to which
you are actually sending traps.

Enabling Traps

The snmp-server enable traps command enables SNMP traps or specific types of
traps and allows this SNMP management station (the BSR) to send an unsolicited
notification to one or more pre-configured management stations that are identified to
receive traps with the snmp-server host command. For the SNMP management
station to send traps, at least one SNMP-server host must be configured with the
snmp-server host command and traps globally enable the trap through the
snmp-server enable traps command.
The no snmp-server enable traps command entered with no keywords disables
traps, but not informs, to the host.
Follow these options to configure and enable SNMP traps:
4-12
Use the snmp-server enable traps command in Global Configuration mode to
enable SNMP traps. This command configures the BSR to send SNMP traps. If
you do not specify the trap type, all trap types are enabled.
MOT (config)#snmp-server enable traps [bgp | docsdevcmts | entity |
environ | flap | ospf | pim | registration | snmp]
where:
traps enables BGP, OSPF, and SNMP state change traps.
bgp enables BGP state change traps.
docsdevcmts enables DOCSIS device CMTS traps.
entity enables entity state change traps.
flap enables flap state change traps.
MGBI
Release 1.0
526360-001-00 Rev. B