Reserving Downstream Bandwidth; Unreserving Downstream Bandwidth - Motorola BSR 2000 Configuration And Management Manual

Release 1.0
1. Use the cable downstream shutdown command in Interface Configuration mode
2. Use the no cable downstream shutdown command in Interface Configuration
3. Use the show interfaces cable command in Privileged EXEC mode to verify that

Reserving Downstream Bandwidth

Use the cable downstream reserve-bandwidth command to reserve a specified
amount of downstream bandwidth for CMs, in Interface Configuration mode:
MOT (config-if)# cable downstream <0-0> reserve-bandwidth <1-38469736>
where:

Unreserving Downstream Bandwidth

Use the cable downstream unreserve-bandwidth command to unreserve a specified
amount of downstream bandwidth for CMs, in Interface Configuration mode:
MOT (config-if)# cable downstream <0-0> unreserve-bandwidth
<1-38469736>
where:
526360-001-00 Rev. B
to optionally disable a downstream port if it must be reset:
MOT (config-if)# cable downstream <0-0> shutdown
where:
0-0 is the downstream port number.
mode to enable the downstream port again:
MOT (config-if)# no cable downstream shutdown
the downstream port is activated:
MOT # show interfaces cable 0
0-0 is the downstream port number.
1-38469736 is the amount of downstream bandwidth in bits per second.
0-0 is the downstream port number.
1-38469736 is the amount of downstream bandwidth in bits per second.
MGBI
Configuring the CMTS
6-51