Enabling Local Policy-Based Routing On A Router; Gathering Routing Policy Information - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide

Enabling Local Policy-Based Routing on a Router

Local policy-based routing is applied to all packets originating from this router. Use
the ip local policy route-map command in Global Configuration mode to enable
local policy-based routing on a router and to indicate which route map the router
should use:
MOT (config)# ip local policy route-map <WORD>
All packets originating on the router will now be subject to local policy-based routing.
Use the no ip local policy route-map <WORD> command to disable local
policy-based routing on the router. Use the show ip local policy command to display
the route map used for local policy-based routing, if one exists.

Gathering Routing Policy Information

Use the following show commands to monitor routing policies:
1. Use the show access-lists from any mode to display an access list or all access
2. Use the show ip as-path-access-list display the configured AS path access lists.
3. Use the show ip bgp dampened-paths to display the entries in the routing table.
4. Use the show ip community-list from Global Configuration mode to display the
8-18
lists. The resulting display includes the instances of each access list.
MOT #show access-lists [<1-199> <1300-2699>]
where:
1-199 and 1300-2699 is the access list number or numbers.
The resulting display includes the instances of each AS path access list.
MOT #show ip as-path-access-list [<1-199>]
where:
1-199 is the access list number.
The resulting display includes the instances of each access list.
MOT # show ip bgp dampened-paths
configured community access list.
MOT (config)#show ip community-list [<1-99> | <100-199>]
where:
1-99 is the standard community list number
MGBI
Release 1.0
526360-001-00 Rev. B