Connecting Coaxial Cables To The Bsr 2000; Connecting A Coaxial Cable To The Downstream Channel Port; Connecting Coaxial Cables To The Upstream Channel Ports - Motorola BSR 2000 Installation Manual

BSR 2000 Installation Guide
Figure 2-9 Connecting a Cable to the T1/E1 BITS Interface Port

Connecting Coaxial Cables to the BSR 2000

The BSR 2000 has one downstream channel and four upstream channels. The ports
for these channels, shown in

Connecting a Coaxial Cable to the Downstream Channel Port

To connect cables to the downstream channel port, follow these steps and refer to
Figure
1. Identify the downstream channel connector (DS0) on the BSR 2000 rear panel.
2. Insert the center conductor of the downstream channel cable into the small
3. Secure the connection by screwing the outside cable connector housing onto the

Connecting Coaxial Cables to the Upstream Channel Ports

To connect cables to the upstream channel ports follow these steps and refer to
Figure
2-14
RED BITS
To T1/E1-based
BITS source
2-10.
The port is color-coded with an orange label.
opening at the center of the BSR 2000 downstream channel connector.
BSR 2000 downstream connector until finger tight; then using a wrench, tighten
the connector one-quarter turn (15 in.-lbs when using a torque wrench).
2-10.
0 1 2 3 4 5
bsr2k030
Figure 2-10, are located on the BSR 2000 rear panel.
MGBI 526359-001