Creating A Spectrum Group - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide
Defining a spectrum group contains the following tasks outlined in this section:

Creating a Spectrum Group

Follow these steps to create a cable spectrum group:
1. Use the cable spectrum command in Global Configuration mode to create a
Note: No spaces are allowed for the spectrum group name.
6-136
Spectrum hopping rules determine the action taken when the spectrum manager
decides to change the parameters of an upstream channel to combat noise.
Operators can improve upstream channel conditions to combat ingress noise by
specifying hopping rules for upstream frequency changes, upstream frequency
band changes, modulation profile changes, channel-width reduction (until
channel conditions improve), and power adjustments (if it is necessary).
Creating a Spectrum Group
Scheduling the Availability of a Spectrum Group Band
Scheduling the Removal of a Spectrum Group Band
Configuring Spectrum Data Collection
Configuring Spectrum Hopping Rules
Configuring the Spectrum Hopping Error Threshold
Configuring the Spectrum Hopping Flap Threshold
Enabling and Disabling Spectrum Roll-back
Configuring the Guard Band
Reviewing the Spectrum Group that You Created
cable spectrum group and enter the new mode in which to configure your cable
spectrum group:
MOT(config)#cable spectrum <WORD>
where:
WORD is the spectrum group name.
MGBI
Release 1.0
526360-001-00 Rev. B