Clearing Route Flap Dampening; Shutting Down A Neighbor Or Peer Group - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide
These commands specify AS path access list 1 as the filter to determine the permitted
ASs.

Clearing Route Flap Dampening

Follow these steps to clear route flap dampening:
1. Use the clear ip bgp dampening command in Privileged EXEC mode to clear all
2. Use the clear ip bgp dampening command in Router Configuration mode to
Example
The following example clears route dampening information about the route to
network 170.0.0.0 and unsuppresses its suppressed routes. If you do not specify the
address and mask arguments, the clear ip bgp dampening command clears route
dampening information for the entire BGP routing table.
MOT(config-bgp)#

Shutting Down a Neighbor or Peer Group

Follow these steps to disable a BGP neighbor or peer group:
1. Use the neighbor shutdown command in Router Configuration mode to
12-16
MOT(config)#router bgp 100
MOT(config-bgp)#bgp dampening route-map dallas
MOT(config-bgp)#route-map dallas permit 10
MOT(config-bgp)#ip as-path access-list 1
MOT(config-bgp)#set dampening 5 1000 1500 15
MOT(config)#ip as-path access-list 1 deny ^300
MOT(config)#ip as-path access-list 1 permit any
route dampening information:
MOT#clear ip bgp dampening
unsuppress a suppressed route:
MOT(config-bgp)#clear ip bgp dampening <A.B.C.D> <A.B.C.D>
where:
A.B.C.D is the network IP address.
A.B.C.D is the network mask applied to the address.
clear ip bgp dampening 170.0.0.0 255.255.0.0
terminate any active session for a specified BGP neighbor or peer group and
remove all associated routing information:
MGBI
Release 1.0
526360-001-00 Rev. B