Using Set Statements To Define Routing Conditions - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide
6. Use the match metric command in Global Configuration mode to match a
Note: The match metric for BGP is Multi-Exit Discriminator (MED).
7. Use the match route-type external command in Route Map Configuration mode
8. Use the match tag command in Route Map Configuration mode to match one or

Using Set Statements to Define Routing Conditions

Set statements define the conditions that apply to the route. If a route meets the
conditions of an instance, some or all set statements are applied, depending on the
usage of the route-map. The order of match statements within an instance is not
relevant since either all or none are applied.
If an instance has no set statements and all the match statements match, nothing is set
for the route. The route is simply redistributed, advertised, or learned as is (depending
on where the route map is applied).
Follow these steps to change attributes of a route.
1. Use the set as-path prepend command in Route Map Configuration mode to
8-4
routing metric value:
MOT (config-rmap)#match metric <0-4294967295>
to match external route types:
MOT (config-rmap)#match route-type external [type-1 | type-2]
where:
external indicates OSPF routes.
type 1 matches only type 1 external routes (for OSPF).
type 2 matches only type 2 external routes.
Use the no match route-type command if you need to disable matches and
external route redistribution.
more tag values of the destination protocol and set the rules for routes:
MOT (config-rmap)#match tag <0-4294967295> [...0-4294967295>]
modify an AS path:
MGBI
Release 1.0
526360-001-00 Rev. B