Configuring Logging Reports - Motorola BSR 2000 Configuration And Management Manual

Release 1.0
4. Use the show log command in Privileged EXEC or Global Configuration mode to
Clearing the Logging Buffer
1. Clear the logging buffer with the clear log command in all modes except User
2. Verify that the log has been cleared with the show log command in all modes

Configuring Logging Reports

You can configure the BSR to automatically generate logging reports. You can select
the report type, storage location, and the severity of log messages to be entered into
the report.
To configure a logging report, specify the logging report configuration with the
logging reporting command in Global Configuration mode:
526360-001-00 Rev. B
see messages logged in the internal buffer. The oldest message is displayed first.
EXEC:
MOT #clear log
except User EXEC:
MOT #show log
MOT (config )# logging reporting {alerts | critical | debug | default |
emergencies | errors | informational | notifications | warnings} {all-clear |
all-set | local | local-syslog | local-trap | local-trap-syslog}
where:
alerts logs conditions where immediate action is needed
critical logs critical conditions
debug logs debugging messages
default sets all severity levels to the default destination/severity
emergencies logs emergency conditions where the system is unusable
errors logs error conditions
informational logs informational system messages
notifications logs normal but significant conditions
warnings logs warning conditions
all-clear insets all logging locations for the report.
all-set sets all logging locations for the report
MGBI
Configuring the System
3-23