Motorola BSR 2000 Configuration And Management Manual page 382

BSR 2000 Configuration and Management Guide
6-196
Table 6-22 Cable Modem Connectivity States
Connectivity State
online(pt)
reject(m)
reject(c)
reject(r)
reject(pk)
reject(pt)
offline
Use the following options to view Customer Premises Equipment (CPE)
information:
•
If you want to display CPE information for all cable interfaces, use the show
cable modem-cpe command as shown bellow:
MOT# show cable modem cpe
•
If you want to display information for a CPE IP or MAC address, use the
show cable modem cpe command:
MOT# show cable modem cpe [<mac> | <prefix>]
where:
mac is the CPE MAC address.
prefix is the CPE IP address.
•
If you want to display CPE information for a particular upstream port, use the
show cable modem cpe upstream command:
MOT# show cable modem cpe <X/Y> upstream <NUM>
where:
X is 0.
Y is the port number.
Identification
CM registered; BPI enabled, and traffic
encryption key (TEK) is assigned.
CM did attempt to register; registration was
refused due to bad mic.
CM did attempt to register; registration was
refused due to bad COS.
CM did attempt to register, registration was
refused due to unavailable resource.
KEK modem key assignment is rejected.
TEK modem key assignment is rejected.
CM is considered to be offline.
MGBI
Release 1.0
526360-001-00 Rev. B