Enabling Cmts Traps - Motorola BSR 2000 Configuration And Management Manual

Release 1.0

Enabling CMTS Traps

CMTS traps are enabled with the snmp-server docs-trap-control command in
Global Configuration mode, as follows:
MOT (config)#snmp-server docs-trap-control {cmtsBPKMTrap |
cmtsBpiInitTrap | cmtsDCCAckFailTrap | cmtsDCCReqFailTrap |
cmtsDCCRspFailTrap | cmtsDynServAckFailTrap | cmtsDynServReqFailTrap |
cmtsDynServRspFailTrap | cmtsDynamicSATrap | cmtsInitRegAckFailTrap |
cmtsInitRegReqFailTrap | cmtsInitRegRspFailTrap}
CMTS Trap Name
cmtsBPKMTrap
cmtsBpiInitTrap
cmtsDCCAckFailTrap
cmtsDCCReqFailTrap
cmtsDCCRspFailTrap
526360-001-00 Rev. B
ospf enables OSPF state change traps.
pim enables PIM state change traps.
registration enables CM (de)registration traps
snmp enables SNMP state change traps.
Table 4-2 describes each CMTS trap in detail.
Table 4-2 CMTS Trap Definitions
Definition
the failure of a BPKM operation detected on the
CMTS side
the failure of a BPI initialization attempt happened
during the CM registration process and detected on
the CMTS side
the failure of a dynamic channel change
acknowledgement that happened during the
dynamic channel change process on the CMTS
side
the failure of a dynamic channel change request
that happened during the dynamic channel change
process on the CM side and detected on the CMTS
side
the failure of a dynamic channel change response
that happened during the dynamic channel change
process on the CMTS side
MGBI
Configuring SNMP
4-13