Scheduling The Availability Of A Spectrum Group Band - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide

Scheduling the Availability of a Spectrum Group Band

The time band command is used to schedule when a spectrum group band is
available. The spectrum group band can be made available on either a daily or weekly
schedule.
Follow these steps to schedule the availability of a spectrum group band:
1. Use the cable spectrum command in Global Configuration mode to enter Cable
Note: If a new availability time for a band is entered for a spectrum group, the
existing availability time for a band must be deleted first.
2. If you want to schedule the time for when the spectrum group band becomes
6-138
•
If you need to add another start and end frequency band to the spectrum
group, repeat this step.
•
If you need to delete a start and end frequency band from a spectrum group,
use the no band command as shown below:
•
MOT(config-spcgrp: <WORD>)#no band {<5000000-42000000>
<5000000-42000000>}
Spectrum Group mode:
MOT(config)#cable spectrum <WORD>
where:
WORD is the spectrum group name.
The Cable Spectrum Group mode displays for the spectrum group.
available on a daily basis, use the time band command in Cable Spectrum Group
mode:
MOT(config-spcgrp: <WORD>)#time <hh:mm:ss> band
{<5000000-42000000> <5000000-42000000>}
where:
WORD is the spectrum group name.
hh:mm:ss is the time of the day, which includes the hour, minute, and second
when the band becomes available.
MGBI
Release 1.0
526360-001-00 Rev. B