Release 1.0
Determining the Modulation Profile Applied to an Upstream
Port
Follow these steps to determine which modulation profile is applied to a specific
upstream channel:
1. Navigate to Cable Interface Configuration mode, as follows:
2. Use the show cable upstream command, in Cable Interface Configuration mode,
526360-001-00 Rev. B
MOT(config)#interface cable <X/Y>
where:
X is 0.
Y is the MAC Domain.
to determine which modulation profile is applied to an upstream port, as shown
below:
MOT(config-if)#show cable upstream {<NUM> | <X/Y>}
where:
NUM is the upstream port number.
X/Y is the upstream port number and logical channel number (0-3).
MGBI
Configuring the CMTS
6-63