Configuring The Multimedia Gate Timer T1; Configuring Related Tasks; Clearing All Cops Connections - Motorola BSR 2000 Configuration And Management Manual

Release 1.0

Configuring the Multimedia Gate Timer T1

The Multimedia Gate Timer T1 has a default setting for the interval that elapses
between authorizing and reserving a PacketCable Multimedia gate.
The multimedia T1 timer starts when a gate is authorized. The Multimedia T1 timer is
stopped when an operation is performed (e.g. The gate state is switched to Reserved).
On expiration of this timer, the BSR deletes the gate.
Follow these steps to configure the multimedia T1 timer:
1. Issue the mm t1-timer command in PacketCable Configuration mode to
2. Issue the show packet-cable configuration mm command to verify the

Configuring Related Tasks

Follow the procedures in these sections to configure related PacketCable tasks:

Clearing All COPS Connections

Issue the clear cops pdp-ip all command in PacketCable Configuration mode to
remove all Policy Decision Point (PDP) IP addresses, which causes all COPS
connections to be cleared.
526360-001-00 Rev. B
configure the multimedia T1 timer:
MOT(config-pktcable)# mm t1-timer <1-3600>
where:
1-3600 is the timer value in seconds. The default is 200.
Multimedia T1 Timer setting.
Clearing All COPS Connections
Enabling the COPS Status SNMP Trap
Clearing Gates
Clearing PacketCable Statistics
Clearing PacketCable Configuration
MGBI
Configuring PacketCable
7-37