Interface Configuration Mode; Service Class Configuration Mode; Packetcable Configuration Mode - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide

Interface Configuration Mode

Interface Configuration commands modify the operation of an interface, such as an
Ethernet port, and allow you to enable features on a per-interface basis. Interface
Configuration mode is available for cable, Ethernet, GigaEthernet, and loopback
interface types. The following command example shows how to enter Interface
Configuration mode for a cable interface from Global Configuration mode:
MOT (config)#interface cable <X/Y> <Enter>
MOT (config-if)#
X = 0
Y = the cable port number
To exit Interface Configuration mode and return to Global Configuration mode, enter
the exit or end commands. To exit Interface Configuration mode and return to
Privileged EXEC mode, press Ctrl-Z.

Service Class Configuration Mode

Service Class Configuration mode is accessed from a cable interface. Upstream and
downstream QoS parameters can be configured on the cable interface for new or
default service classes. The following command example shows how to enter Service
Class Configuration mode from Global Configuration mode:
MOT (config)#cable service-class <Enter>
MOT (config-srvclass)#
To exit Service Class Configuration mode and return to Global Configuration mode,
enter the exit or end commands. To exit Service Class Configuration mode and return
to Privileged EXEC mode, press Ctrl-Z.

PacketCable Configuration Mode

PacketCable Configuration mode is used to configure Dynamic Quality of Service
(DQoS) and Event Message parameters for PacketCable. The following command
example shows how to enter PacketCable Configuration mode from Global
Configuration mode:
MOT (config)#packet-cable <Enter>
MOT (config-pktcable)#
2-6 MGBI
Release 1.0
526360-001-00 Rev. B