Disabling A Cable Intercept - Motorola BSR 2000 Configuration And Management Manual

Release 1.0
6. Use the show interfaces cable intercept command to view intercept information
Figure 6-15
MOT(config-if)#show interfaces cable 0/0 intercept
MAC Address
0000.0001.0201
0000.0001.0301
0000.0001.0401
0000.0001.0501
0000.0001.0601
0000.0001.0701
Figure 6-15 show interfaces cable intercept Command Output

Disabling a Cable Intercept

Follow these steps to disable a cable intercept for a particular CPE on a DOCSIS
network:
1. Use the interface cable command in Global Configuration mode to enter the
2. Use the no cable intercept command in Interface Configuration mode to delete a
526360-001-00 Rev. B
for each intercepted CPE MAC address. Each destination IP address and UDP
port for the data collection server are displayed and the total number of packets
and bytes that are intercepted from this CPE are also displayed:
MOT(config-if)# show interfaces cable <X/Y> intercept
where:
X is 0.
Y is the port number.
displays information for several intercept CPE entries:
Destination
IP Address
10.14.38.52
10.14.38.52
10.14.38.52
10.14.38.52
10.14.38.52
10.14.38.52
cable interface on which cable intercepts are configured:
MOT(config)# interface cable <X/Y>
where:
X is 0.
Y is the port number.
cable intercept on the cable interface:
MOT(config-if)# no cable intercept <mac> <prefix> <0-65535>
Destination
UDP Port Packets
1900 162729616
1900 157004480
1900 153686536
1900 140844360
1900 140835768
1900 140837200
MGBI
Configuring the CMTS
Bytes
113638
109640
107323
98355
98349
98350
6-187