Motorola BSR 2000 Configuration And Management Manual page 514

BSR 2000 Configuration and Management Guide
Displaying Virtual Links
The show ip ospf virtual-links command displays parameters regarding the current
state of the OSPF virtual links.
MOT# show ip ospf virtual-links
Displaying OSPF Interface Information
Use the following options to display OSPF interface information:
ethernet 0/0 is up, line protocol is up
Internet Address 8.1.1.10/24, Area 0
Router ID 9.1.1.1, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State BDR, Priority 1
Designated Router (ID) 172.17.82.152, Interface address 8.1.1.1
Backup Designated Router (ID) 9.1.1.1, Interface address 8.1.1.10
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 172.17.82.152
ethernet 0/0 is up, line protocol is up
Internet Address 33.3.2.3/24, Area 0
Router ID 9.1.1.1, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 9.1.1.1, Interface address 33.3.2.3
Backup Designated Router (ID) 0.0.0.0, Interface address 0.0.0.0
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 0, Adjacent neighbor count is 0
ethernet 0/0 is up, line protocol is up
Internet Address 33.4.2.3/24, Area 0
Router ID 9.1.1.1, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
11-24
Use the show ip ospf interface command to display information about all
interfaces on which OSPF is configured.
Figure 11-4 displays typical show ip ospf interface command output:
Figure 11-4 show ip ospf interface Command Output
- or -
(Designated Router)
MGBI
Release 1.0
526360-001-00 Rev. B