Specifying Specific Trap Types - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide
2. Use the no snmp-server host command to remove the specified host.
Note: If the community-string is not defined using snmp-server community
command prior to using the snmp-server host command, the default form of
the snmp-server community command is automatically inserted into the
configuration. The password (community-string) used for this default
configuration is the same as that specified in the snmp-server host
command.
When removing an SNMP trap host from the trap host list with the no
snmp-server host command, the community name that is specified in the
command must exist. If the community name does not exist, the command
will fail.

Specifying Specific Trap Types

Use the snmp-server host traps command in Global Configuration mode to
configure an SNMP trap host to receive specific trap types as shown below. If no trap
type is specified, all traps are sent to this trap host.
MOT (config)#snmp-server host <A.B.C.D> traps {<WORD>} [udp-port
<0-65535>] [bgp | docsdevcmts | entity | environ | flap | ospf | pim | snmp]
where:
4-10
traps indicates enable SNMP traps.
informs indicates enable SNMP informs.
WORD is the SNMPv1/v2c community string or SNMPv3 user name.
version indicates the version of notifications. If no version keyword is
specified, the default is version 1.
1 is the SNMP version 1 message processing model.
2c is the SNMP version 2c message processing model.
3 auth is the SNMP version 3 message processing model with authentication
and uses unscrambled packets.
3 noauth is the SNMP version 3 message processing model with no
authentication and uses unscrambled packets.
3 priv is the SNMP version 3 message processing model that authenticates
and scrambles packets.
MGBI
Release 1.0
526360-001-00 Rev. B